Hansgrohe 32040821 Manuel d'instructions télécharger pdf (Page 3)

Connect the supply hoses to the hot and cold stops.

Use two wrenches, as shown in the

diagram, to prevent hose twisting.

For proper operation of the faucet, the hot supply

should be on the left, and the cold supply should be

on the right.

Install the pop-up drain and pull rod.

Turn on the water and check all connections for

leaks.

If desired, set the high temperature limit stop.

Installation

Flush the hot and cold supplies thorough-

ly before installing the faucet.

Place the faucet and sealing washer on

the mounting surface.

If the mounting surface is less than 3/16”

thick, trim the sealing washer so that it

is even with the bottom of the mounting

surface.

Install the slide washer and collar nut.

Tighten the collar nut by hand.

1 2 3 4 5 6 7 8

Pas de commentaire

Hansgrohe 32040821 Manuel d'instructions Page 3